Mokume Wave cutter Texture Stamp

Allow for slight colour difference depending on screens

Handmade Unique One Off Polymer Clay Cutters

• Material: PLA texture stamp 
• Size: L140mm x H11mm . Allow 5mm variance for hand measuring
• 
  
• Stamp Care:
  -Hand wash with soap and water
  -Store in a cool, dry place
  -Do not wash in a dishwasher
  -Do not keep in direct sunlight or expose to heat
• Use:                                                                                                                         
  
• These stamps do not have a handle, so they need to be lifted from the clay/soap from the edges. However, you can easily glue them to a wooden block to create a handle.
  
  The stamp works on clay slabs or soap of any thickness. I recommend trying the cutters on a scrap slabs first to practice adjusting the pressure.
  
  
• I would recommend placing Plastic film on your clay, especially if cutter has alot of fine details. Press evenly then give a little wiggle and cutter should remove clean.                                                                                                                       For best results, clay thickness should be a minimum 3mm       
• 
  
  Press the stamp firmly but gently and evenly. In order to avoid breaking the stamp, don't press too hard and don't apply sideways pressure. Some parts of the stamp are designed to be thin in order to obtain a defined embossing.
  
  Due to the type of printing (3D) some bumps might be present on the stamps where the filaments join. The marks of the bumps are very light and can be easily removed before or after curing.                                                                                                                                                                            
  
•                            
  
• Colour: Clear